hatmoose

I repaired one of my controllers with the kit, and I have no issues with sensitivity, it's just as responsive as the original kit and...

If you are up for it, why not populate the P1 and C1 slots with the monitor test tool? I did that on a custom NeoSD rom pack I made...

Ten bucks says there is at least one trace that broke connection from the corrosion. Which is always the worst because hunting down...

replacing the NEO-BUF with jumpers can work according to the NeoGeoDev wiki on the MVB for GA1, I'm sure you're aware...

Forgot about this one in my passive pile of half finished projects I'm now pretty sure this CHA42G-1 board is not a fake - suspect it...

This one came to me for repair from a buddy who had bravely (foolishly?) bought it off Aliexpress It's now actually not much cheaper to...

Finally got this in from Ali...it's ehhhh - pretty much identical picture quality to the KAICO HDMI adapter. So, for anyone curious - avoid

Echo... Echo.... Echo...

For those interested https://www.laserbear.net/products/neogeo-cd-clicky-pad-repair-kit

Loving the concept and the music - was hoping for more scan lines. Current plan is to downscale it from 1080p to 480i - then run it...

Ok, so my MV2F board was repaired by BB and he did an amazing job fixing all of the known corrosion issues, sound issues, etc. I've...

DirtyPCBs should be pretty damn cheap but they don't do assembly.

Thanks! Have used JCLPCB and PCBway, but had not tried Gerber Labs, will check them out. Agree that for the money JCL are a clear...

Nothing specific at this stage - I've started experimenting with Kicad and it's much easier to make a nice looking 4-layer board. But...

I have used 3 places, but all for 2 layer boards. In order of quality best -> worst IMHO: JLCPCB Gerber Labs PCBWay The HASL finish on...