Hello there!
Recently, i got an old MVS reproduction cabinet with a MV1FZ inside. It was missing some parts and it had a bad PSU.
So i gathered what was missing and got a working PSU, problem is when i turned it on all i got was a garbled screen with moving bars.
So, i took the board off and went to a friend that has an MVS cabinet and installed it there, but again all i got was this garbled screen...
He offered to test his board on my cabinet, and it worked out just fine. So i guess my cabinet PSU and wiring are correct.
Here is a photo of the screen: (The tube has a blue tint wich i could not fix yet)
Also, before creating this thread i took a measure of the 5V and 12V.
The readings where:
With the board connected : 4.35V and 11.72V
Without the board (only PSU) 5.07V and 12.10V
Well, with all being said i'm kinda lost and could really use any help of where should i begin.
Recently, i got an old MVS reproduction cabinet with a MV1FZ inside. It was missing some parts and it had a bad PSU.
So i gathered what was missing and got a working PSU, problem is when i turned it on all i got was a garbled screen with moving bars.
So, i took the board off and went to a friend that has an MVS cabinet and installed it there, but again all i got was this garbled screen...
He offered to test his board on my cabinet, and it worked out just fine. So i guess my cabinet PSU and wiring are correct.
Here is a photo of the screen: (The tube has a blue tint wich i could not fix yet)
Also, before creating this thread i took a measure of the 5V and 12V.
The readings where:
With the board connected : 4.35V and 11.72V
Without the board (only PSU) 5.07V and 12.10V
Well, with all being said i'm kinda lost and could really use any help of where should i begin.