Does anyone have a list of all the electrolytics required (capacitance, voltage) for re-capping the sound section on a 6 slot please? I think that there are about 30 caps in total.
Thanks
I have a Hyper Bishi Bashi Champ that is reporting three (of the eight) Flash chips as 'Bad' on power up as part of its self test.
None of my programmers will handle this type of Flash (TSOP48, 29F016A-90PFTN which is
16M-BIT [2M X 8] ) and I'm trying to find somebody in the UK who can handle...
What is the EPROM equivalent of a 40-pin '4M-16Bit' mask ROM?
I ask as I'm currently working on a Konami 'Bells & Whistles' PCB with an empty mask ROM socket at 3K. All other chips (custom and otherwise) are fine. Have tried the same mask ROM from a fully working Bells & Whistles and that works...
Just PM'd Xian Xi about this, but in case he's not around thought I'd post this here too.
I want to check that I'm doing this right in the absence of any specific instructions for the particular 1 slot revision that I have. It's a NEO-MVH MV1AX
I want to replace the rechargeable battery with a...
Wonder Boy PCB - 100% Working
http://cgi.ebay.co.uk/ws/eBayISAPI.dll?ViewItem&item=300460472743
Choplifter PCB - 100% Working
http://cgi.ebay.co.uk/ws/eBayISAPI.dll?ViewItem&item=300460473986
Shinobi PCB - 100% Working
http://cgi.ebay.co.uk/ws/eBayISAPI.dll?ViewItem&item=300460471747
A friend has a Zed Blade cart with badly corroded and broken pins on the P1 40-pin mask ROM.
I want to replace this mask ROM with a newly programmed EPROM, but what type of EPROM can be used as a drop in replacement? File size is 524288 bytes but there are a few EPROMs with that capacity which...
Super Contra PCB, JAMMA, original - 100% Working
http://cgi.ebay.co.uk/ws/eBayISAPI.dll?ViewItem&item=300390107641
Space Lords PCB, JAMMA+, original
http://cgi.ebay.co.uk/ws/eBayISAPI.dll?ViewItem&item=300390112136
Bucky O'Hare PCB - JAMMA, Original - 100% Working
http://cgi.ebay.co.uk/ws/eBayISAPI.dll?ViewItem&item=300373835869
Blade Master PCB - JAMMA, Original - 100% Working
http://cgi.ebay.co.uk/ws/eBayISAPI.dll?ViewItem&item=300376056999
Has anyone ever tried to repair a Sega STV cart? Just curious if there are any common points of failure, etc.
Don't they also contain a couple of PALs?
Are the ROM boards interchangeable to any extent between the ZN-1 and ZN-2 ? I'd be very surprised if they were, but someone I know has asked me.
Thanks