- Joined
- Mar 8, 2002
- Posts
- 3,686
So, since I have the 1st generation AES I have sync at pin 7?
Yes.
Should I open the DIN end of the cable you made and move the wire from pin 3 to pin 7 and give that a try?
That's easier said than done. Opening the DIN plug would be difficult for me and probably impossible for you. The rubber strain relief will not slide back on the cable without lubricant applied under it. Believe me, you risk making the cable unusable.
It would be easier to mod the system. You just need to remove a resistor and move one side of another resistor, as shown in this pic:
http://img189.imageshack.us/img189/5549/s20200681.jpg
(I can give you tips on how to do this easily)
Does the euro J adapter need to be changed also?
No.
Last edited: