Wei-Ya 828HR replacement chassis?

[not sonic]

i have a tube with a bad wei-ya 828hr chassis.

i'd like to get it replaced. tri sync would be cool, but low or low/med would be fine with me.

any ideas?

i can get more specifics about the number of neck board pins and such if needed.

i tried talking to the guy at alvaamusement.com a while back but never got any reply when i wanted to buy one.

 

[not sonic]

im sure no one cares but the guy at alvaamusements got back to me.

Chassis 25~27"" CH-826HR ,(V=9 ~ 15 OHM) HR=1.3 OHMS STD Res (NEGATIVE SYNC)(WIRED CONTROL REMOTE), IT MUST USE ISOLATION TRANSFORMER $ 76.00

looks like ill have a spare monitor again.

 

[billd420]

Make sure to check the CRT sockets number of pins, as well as the resistance on the yoke. You need to measure the ohms between the two axis (on the 4 pin yoke connector). If they don't match, you risk ruining your tube with an incompatible chassis.

Chances are it will work since ALVA sells WeiYah chassis, however I'd double check to be sure.