I have a SNES Mini incoming and am looking into whats the consensus here is on the best way to mod it for rgb.
The standard mod seems straight forward - connect rgb from the s-rgb chip to the av connector through 75ohm resistors and connect csync (will be using a cable wired for csync).
However I have a spare RGB amp kit from Broken - can anybody say whether its worth bypassing the stock SNES mini encoder and using that instead? since this is my only spare, i would expect a notable differenc3 if i am to go this way. In such a case I take it I don't necessery need the 75 ohm resistors on the rgb lines?
I also seen certain schematics where the rgb lines were connected to ground by a 75ohm resistor - kind of the same termination as in the pal snes cables - any views on this?
Any tips and comments welcome.
The standard mod seems straight forward - connect rgb from the s-rgb chip to the av connector through 75ohm resistors and connect csync (will be using a cable wired for csync).
However I have a spare RGB amp kit from Broken - can anybody say whether its worth bypassing the stock SNES mini encoder and using that instead? since this is my only spare, i would expect a notable differenc3 if i am to go this way. In such a case I take it I don't necessery need the 75 ohm resistors on the rgb lines?
I also seen certain schematics where the rgb lines were connected to ground by a 75ohm resistor - kind of the same termination as in the pal snes cables - any views on this?
Any tips and comments welcome.