DavidG
REAL NAME: Jason Young, KNOWN SCAMMER, , This con-
- Joined
- Nov 12, 2010
- Posts
- 372
I've seen a few post now that have asked for this to be done. I had a full day off today due to a lot of snow paying a visit and I spent most of it on this project. Over all I would have to say I am 70% done before I can make a prototype to test with the MV-1B.
I'm not sure if this is fully possible yet, I don't think I will know until the very end. Based on the work I have done so far its looking very good. By Sunday I should know if this will work and will move towards a working prototype.
In the converter post we touched on the idea of having sram for saves stored on a converter. Before today I didn't think it would work but after todays work that might be possible.
Due to the size of the MV-1B space is going to be the issue. Perhaps we can combine a few projects into one and get a single board that adds a DIP socket for the unibios and selectable on board memory NTM had done.
I'm not sure if this is fully possible yet, I don't think I will know until the very end. Based on the work I have done so far its looking very good. By Sunday I should know if this will work and will move towards a working prototype.
In the converter post we touched on the idea of having sram for saves stored on a converter. Before today I didn't think it would work but after todays work that might be possible.
Due to the size of the MV-1B space is going to be the issue. Perhaps we can combine a few projects into one and get a single board that adds a DIP socket for the unibios and selectable on board memory NTM had done.