Gyrian
Hardened Shock Trooper
- Joined
- Mar 24, 2016
- Posts
- 443
I'll add another +1 for the rf shield removal advice. I removed the plate from my cdz unit thanks to advice I read on this forum some years ago. Never had any issues (just keep the unit in a relatively dust free environment). Removing the plate is super easy.
1. Remove the four bottom screws and lift the top covering/shell from the unit.
2. Carefully remove all visible screws that hold the board to the bottom shell.
3. Lift the laser assembly and remove all screws you see underneath where the laser assembly was and beneath the small pcb to the left of the laser assembly.
4. Remove the metal plates that were seated below the laser assembly and the smaller pcb.
5. Lift the board out of the plastic shell and discard the rf sheilding plate that resides below it.
6. Reassemble the unit.
Thanks for the breakdown! Rather straightforward.