Wired up my SCART cable to individual RCA's today as below.
1: Red, Red Ground
2: Green, Green Ground
3: Blue, Blue Ground
4: Blanking (180ohm), Blanking Ground
5: Sync, Common Ground
I've yet to wire up Audio but it would be as follows,
6: Audio Input A, Audio Ground
7: Audio Input B, Audio Ground
Tested on my Loewe CRT without any resistors on the colour lines as a first test, colours look good but I saw some bleeding of colour especially on the 'SNK' logo. The blue was bleeding out as if it was smudged with someones finger. Unsure if this is because the lack of resistors on the colour lines or if this could be an issue with my CRT.
Also, with my Loewe, I've noticed a 'clicking' very very faint coming from the back of the tube. No picture distortion other than a bit of blurryness on the outer edges of the picture. Heaters are glowing as they should be, cant see any lightshow inside the case which is good news. Probably just being overcautious but then again I did find it on the side of the road and repaired it myself.
Otherwise ALL GOOD!