Help - connector Jamma in MVS !!!

[MaximaBrazil]

Hi,

Using jamma in the MVS I need to connect all the voltage points?
In MVS Service Manual, Pin# "3", "4", "C" and "D" is for +5V.
I need to connect all to +5V, or alone one of these?

 

[Adamaki]

Just one. If you look on the solder side of the board you will see that the pins are connected by traces anyway.

 

[MaximaBrazil]

Just one. If you look on the solder side of the board you will see that the pins are connected by traces anyway.

But this is the problem, i am have a MV-1FZS and not see the traces !!!

 

[MaximaBrazil]

But this is the problem, i am have a MV-1FZS and not see the traces !!!

I discovered:chimp: , the plate has 4 faces therefore I do not see the traces, 2 faces are internal.

 

[ttooddddyy]

I would connect at least two, like grounds you can not have too many