Controller test problem

[jack sprat]

So, I have an MVS 2 slot with the unibios and when I set it to AES my player 1 control is locked up. In the controller test player 1 directions and buttons are stuck "on"

Anyone know how to fix this?

 

[NEO-GEO man]

Try clearing the back up RAM seems to be the most common reply to these issues, so give that a shot.

 

[jack sprat]

No, that didn't work. It still shows U,D,L,R,A,B,C with 1's "on"

 

[Xian Xi]

What about with your stock bios put back in? Do your regular MVS controls work properly?

 

[jack sprat]

Yes, when it is set to MVS arcade the controls work. But when I set it to AES console, player 1 controls are locked up.
I don't think replacing the stock bios would do much since the problem is just with the AES console setting. But, I guess I could just switch them out and back in just to see if it changes anything.

 

[Xian Xi]

Change your cross input settings in the Unibios.

 

[jack sprat]

I switched the bios but it's still the same. Where do I change the cross input settings?

 

[Xian Xi]

Well, that cross input thing is a feature in the unibios. If it's happening with the stock bios you might have a bad NEO-C1 unless all the resistor packs are all bad.