SavagePencil
Crazed MVS Addict
- Joined
- Oct 17, 2005
- Posts
- 135
Hi all,
I was lucky enough to get one of Furrtek's excellent Fusion MVS -> AES convertors a couple of years back. Something that's bugged me about it is that it's finicky to get in straight, and the spring loaded cart slot doors often make it tough to align it correctly.
I'm looking for a solution where I could either adapt an old AES cart shell around the Fusion, or custom print a new one just for it. I'd like some advice and see if anybody has done anything similar. If there's a repro shell around that I could hack up, I'd much prefer that over using a sac cart.
Any thoughts or advice?
I was lucky enough to get one of Furrtek's excellent Fusion MVS -> AES convertors a couple of years back. Something that's bugged me about it is that it's finicky to get in straight, and the spring loaded cart slot doors often make it tough to align it correctly.
I'm looking for a solution where I could either adapt an old AES cart shell around the Fusion, or custom print a new one just for it. I'd like some advice and see if anybody has done anything similar. If there's a repro shell around that I could hack up, I'd much prefer that over using a sac cart.
Any thoughts or advice?