What mounting plate do I need for this panel?

[skate323k137]

I got a nice panel by way of mjmjr25 by way of scgon, and I need to know what mounting plate I need or what joysticks this thing was made for.

Normal sanwa plates are a couple mm too small (first mounting plate pic). I have a mystery plate (that fits) that I think I nabbed from a madcatz when I put a ls-32 in it for my buddy, but iirc the plate came from the knockoff sanwa that was in the stick to begin with. See 2nd mounting plate pic.

Was this thing made for seimitsu joysticks? does anyone know where I can get another of the mystery plates if I want to use JLFs? If it comes down to it I could demel the sanwa plate to fit but I'd like that to be my last resort.

 

[skate323k137]

Daywalker bump

 

[Lemony Vengeance]

chempop seems to be the resident mounting plate expert. Send him a PM.

 

[codecrank]

looks like a noa-2001 panel. ( stud mount ). Designed for seimitsu.

I'm guessing this is your situation :

Unless someone started making custom plates, you'll have to file the holes in the plate. Either way you'll need washers to bring the plate up the correct height, else the shaft will stick out too far.

 

[skate323k137]

Thanks CC. That is indeed the situation.

If I did want to use seimitsus, any particular model(s) I should go after? will ls-32-01's be the right height with the stock plate?

 

[pipes]

I'd just dremmel all 4 holes out a little bit and you're set.

 

[skate323k137]

I'd just dremmel all 4 holes out a little bit and you're set.

If I decide to use sanwa sticks, that's probably what I'll do. I honestly wouldn't mind having a 2p seimitsu panel either though. My net cities are all set, this thing will be sitting a couple/few months until the cdamm shipment comes in

 

[Chempop]

http://www.kickstarter.com/projects/211853764/universal-arcade-joystick-adapter-plate

Seriously though I am no expert on Sanwa mount plates. If I were to guess I'd say that customized panel was intended for Seimitsu plates.
You could try comparing measurements with the Sanwa JLW-P-1B plate, I found this at Akihabarashop:

 

[codecrank]

Chem, the above plate if for the JLW , it won't fit a JLF.

Thanks CC. That is indeed the situation.

If I did want to use seimitsus, any particular model(s) I should go after? will ls-32-01's be the right height with the stock plate?

ls-32-01 or ls-40-01
RE plate

 

[scgon]

It was one of MCS's panels and his overlay.... awesome stuff!! Can't recall for sure, but seimitsu makes sense based on what's posted above.

 

[Chempop]

I used to actually have one of those same plates. The seimitsu SE plate is what I used with LS-56/58. The RE should also work with LS-32/40 (as codecrank mentioned above).

 

[Mugicha]

I remember seeing that kickstarter, but didn't realize it was for paradise arcade.