MV1C - Sync tap point? (other than jamma pin)

[superfry63]

Just finishing up a MV1C, going through the jamma nation x tutorial, but I've noticed it seems to only refer to the Jamma pins as tap points for R,G,B and sync.

On the same page you can see x3 tap points for the RGB but any idea where the ideal spot for sync can be tapped?



Is the below a good spot to tap or?

 

[Xian Xi]

Easiest is the Jamma pin, you can grab it from GRZ pin 13 or on the back of the board you can tap it at the output of R51.

 

[superfry63]

Great - trying to go with a neat clean install. Your tutorials are fantastic as always.

Thanks,