Jrok rgb controls

I would like to add the rgb controls from the jrok to the front of my supergun. How would I go about doing this? I have seen many superguns that have been shown in the tech forum that have this. Must I desolder the small pots and solder wires from where the old pots are to the new ones. What is the best way to do this? The encoder should have come with directions on what the solder points are so you can properly install it in a box. I would really appreciate some help.

I use three potentiometers (1k ohm) for my supergun. Just connect video signal wire to the center pin of the potentiometer and connect one of the other two pins to the encoder(JROK, NeoBitz etc.). Thta's it.

I did not think it would be that easy. Do I need to ground the potentiometers. I thought that the rgb controls on the jrok would interfere with the new ones I want to install, so this is not true? You have a very nice looking supergun. Thank you for your help.

Trust me it is that easy. You don't need to ground the potentiometers. I believe what I have described will work just fine with JROK.

It is very nice of you to help. Thank you very much.