- Joined
- Jun 29, 2005
- Posts
- 922
Sorry if this is a n00b/stupid thread, but I am wanting some opinions on this subject.
I picked up a good condition Dynamo cab last week. However, the monitor is missing the chassis and the tube has noticeable screen burn. I am wanting to pick up a proper arcade grade LCD monitor and saw a few in the $160 to $200ish range on ebay that goes from 15 - 80 khz. The response time was about 16 ms. All displays on www.displaylag.com that come in at 20 ms and under for gaming monitors are considered "excellent."
With all that stuff said, has anyone been satisfied enough with doing the conversion ? As long as the response time is low enough, is there any problems with motion blur or artifacting ?
Side Note: I think I am mainly going to use it with a NAOMI setup.
I picked up a good condition Dynamo cab last week. However, the monitor is missing the chassis and the tube has noticeable screen burn. I am wanting to pick up a proper arcade grade LCD monitor and saw a few in the $160 to $200ish range on ebay that goes from 15 - 80 khz. The response time was about 16 ms. All displays on www.displaylag.com that come in at 20 ms and under for gaming monitors are considered "excellent."
With all that stuff said, has anyone been satisfied enough with doing the conversion ? As long as the response time is low enough, is there any problems with motion blur or artifacting ?
Side Note: I think I am mainly going to use it with a NAOMI setup.
Last edited: