WG K7000 Top Monitor Curl

E

EveningCommuter

n00b
Joined
Mar 14, 2018
Posts
21
Alright peeps,

So I recently did a monitor swap and installed a new Wells Gardner 25" K7000. Before the monitor swap my previous monitor was lightly burnt and had a curl at the top of the monitor. I swapped it for the K7000 and I again received the same curl but smaller. What could be doing this? I have it connected to a MVS-2 Slot.

Anywhere I should start for troubleshooting?
 

Attachments

  • IMG_6970.jpg
    IMG_6970.jpg
    1.4 MB · Views: 99
B

brad808

n00b
Joined
Nov 7, 2016
Posts
38
Your h-hold looks fine. Try adjusting your vertical range limit. Look for a small potentiometer "vr9" 50-60hz.
 
Westcb

Westcb

Give an Azn, A Break Here!,
Joined
May 17, 2012
Posts
1,190
brad808 said:
Your h-hold looks fine. Try adjusting your vertical range limit. Look for a small potentiometer "vr9" 50-60hz.
Click to expand...

This ^ that image is exactly what it looks like when this is not dialed in. Small turns either direction till it’s fixed.
 
F

FilthyRear

Neo-Geo.com's, Top Rated Bully.,
15 Year Member
Joined
Jan 24, 2007
Posts
8,147
EveningCommuter said:
Alright peeps,

So I recently did a monitor swap and installed a new Wells Gardner 25" K7000. Before the monitor swap my previous monitor was lightly burnt and had a curl at the top of the monitor. I swapped it for the K7000 and I again received the same curl but smaller. What could be doing this? I have it connected to a MVS-2 Slot.

Anywhere I should start for troubleshooting?
Click to expand...

That sign of the left says "Heroin Magic".

Carry on.
 
radiantsvgun

radiantsvgun

They call him Mr. Windy
15 Year Member
Joined
Sep 29, 2007
Posts
1,719
EveningCommuter said:
Alright peeps,

So I recently did a monitor swap and installed a new Wells Gardner 25" K7000. Before the monitor swap my previous monitor was lightly burnt and had a curl at the top of the monitor. I swapped it for the K7000 and I again received the same curl but smaller. What could be doing this? I have it connected to a MVS-2 Slot.

Anywhere I should start for troubleshooting?
Click to expand...

Yeah you need to adjust a seperate pot that’s on the chassis. You also should check your power supply too.
 
Westcb

Westcb

Give an Azn, A Break Here!,
Joined
May 17, 2012
Posts
1,190
EveningCommuter said:
Wait so do I adjust the H Hold or Vertical Range?
Click to expand...

He said your H hold was fine... he said adjust the 50-60hz pot on the chassis. I agreed with his statement. Is this a English is your second language situation? Just turn the pot till the curl subsides. Seen this happen on many Neos, just gotta dial it in and your all set.
 
You must log in or register to reply here.
Top