Vendest
Krauser's Shoe Shiner
- Joined
- Jun 23, 2016
- Posts
- 240
Hi,
1. I am using a double pole on/off switch for the +5v and +12v DC lines while the PSU remains always supplied with AC voltage. It gets really warm inside when the fan and supergun is switched off unless I pull the plug out.
Would it be better to route the AC voltage thru the on/off switch instead of DC voltage?
2. The RGB+sync lines coming from the harness pass very near the internal PSU due to lack of space.
Is there a practical way to shield either the RGB lines or the PSU to avoid noise/interference in the video signal?
Thanks
1. I am using a double pole on/off switch for the +5v and +12v DC lines while the PSU remains always supplied with AC voltage. It gets really warm inside when the fan and supergun is switched off unless I pull the plug out.
Would it be better to route the AC voltage thru the on/off switch instead of DC voltage?
2. The RGB+sync lines coming from the harness pass very near the internal PSU due to lack of space.
Is there a practical way to shield either the RGB lines or the PSU to avoid noise/interference in the video signal?
Thanks