Palette RAM Bank 0 error

pnauts

Kuroko's Training Dummy
Joined
Jun 7, 2017
Posts
76
Hi, I have some trouble on a MV2-01 slot (I think mainly from a bad trace, because it came gradually and flex the board could solve the issue before)

when I perform the Palette RAM test the result is

Adress 400020
actual 0002 ("indirect" D1 stuck high)
expected 0000

I'm sure the problem does not come from the RAM because I swapped them and the error remain the same.

If I remove the lowest RAM the error become

Adress 400000 (the beginning of the Palette bank adress area)
actual 00FD ("indirect" D1 stuck low)
expected 0000
of course the expected should be 00FF in reality as lowest RAM was removed and pulled high by other IC, so there is something related to D1 but through another chip (NEO-B0 ? it's a first gen 2 slot).
It could be also the G0

Any idea welcome.
 

pnauts

Kuroko's Training Dummy
Joined
Jun 7, 2017
Posts
76
what it worth, I suspected the Neo-G0, but it's not. I will try to check the LS273 but I don't think it will be that.
 
Top