The_Vulgar_Ape
n00b
- Joined
- Oct 25, 2019
- Posts
- 3
Hi All,
I am trying to build a console-ized cps2 and was wondering if there is a wiring guide to internally wiring a power supply inside a CPS2 A Board. I am going to use a pico PSU but I'm not sure how to wire the PSU to the A Board. I did some searches but couldn't find any specific instructions. I've seen some photos of someone using the wires from the molex plug and soldering them near the Jamma fingerboard pins, which I assume is to going to the ground, +12V, and +5V pins. However, I could not find details or an explanation as to which, ground and wire pins were used; since the there are multiple 12v and 5v pins. Or maybe it doesn't matter, I'm not sure.
Thanks in advance.
I am trying to build a console-ized cps2 and was wondering if there is a wiring guide to internally wiring a power supply inside a CPS2 A Board. I am going to use a pico PSU but I'm not sure how to wire the PSU to the A Board. I did some searches but couldn't find any specific instructions. I've seen some photos of someone using the wires from the molex plug and soldering them near the Jamma fingerboard pins, which I assume is to going to the ground, +12V, and +5V pins. However, I could not find details or an explanation as to which, ground and wire pins were used; since the there are multiple 12v and 5v pins. Or maybe it doesn't matter, I'm not sure.
Thanks in advance.