doaal
Mr. Big's Thug
- Joined
- May 7, 2018
- Posts
- 209
Hi all,
Recently I bought my first MVS board (MV1ACH) on the cheap. The owner tried to do a stereo mod and had the watchdog colour issue--swapping the stock BIOS to UniBIOS fixed this. Hey, a working Neo! Since he cut the 12v trace I assumed all I had to do was reattach it and I'd have sound, except when I did, the board wouldn't power on. I get a small flicker from my power supply and then it shuts down.
I removed the copper wire I used to connect the trace and the Neo board powers on again as normal. I'm assuming some of the other work the past owner did on the board is causing some kind of issue with the 12v? I've included a picture of the part of the board where the work has been done, along with the cut 12v trace. Aside from what's in these pictures, he installed a battery holder but that's pretty idiotproof.
Any help with this is appreciated.
Recently I bought my first MVS board (MV1ACH) on the cheap. The owner tried to do a stereo mod and had the watchdog colour issue--swapping the stock BIOS to UniBIOS fixed this. Hey, a working Neo! Since he cut the 12v trace I assumed all I had to do was reattach it and I'd have sound, except when I did, the board wouldn't power on. I get a small flicker from my power supply and then it shuts down.
I removed the copper wire I used to connect the trace and the Neo board powers on again as normal. I'm assuming some of the other work the past owner did on the board is causing some kind of issue with the 12v? I've included a picture of the part of the board where the work has been done, along with the cut 12v trace. Aside from what's in these pictures, he installed a battery holder but that's pretty idiotproof.
Any help with this is appreciated.