DaisyAge
Galford's Armourer
- Joined
- Jun 10, 2018
- Posts
- 457
I've tested both ports with 2 AES controllers and they check out fine so I know it is limited to the second player port. I reflowed the pin on the controller port and on the pcb and checked continuity and it came thru fine. Went to hardware test and still no input. Where should I start looking? I don't know where the inputs register. Thank you
Edit: Found a broken trace on the bottom of the board. Must've dragged my soldering iron when I was reflowing the board. All is well again.
Edit: Found a broken trace on the bottom of the board. Must've dragged my soldering iron when I was reflowing the board. All is well again.
Last edited: