I have a late revision AES board where the left/right channels are reversed. I sent my board away for a few mods and the chap did this as an extra for me. only issue, is that rather than connect the left channel to the left pad he connected it to the ground pad by mistake, so I only have sound from the right channel.

I wasn't too fussed as I have mono sound fine and I will prob get around to fixing this myself when I get hold of a soldering iron... my question is, if I leave it as is will is cause any problems with the board? I'm not an electronics expert and the guy said it should be ok but just wanting to make sure...I was thinking it's just a case of the left channel sound is being sent to ground so nothing will happen?

cheers all