Super Neo 29 power supply issue

Some movers fucked up my cab a little while back. The monitor powers on fine and it would play great if I move around some of the cables coming out of the power supply.

It stopped doing that and in the process of messing with it I broke the voltage adjust potentiometer. The spinning screw part fell out. So I took it apart, I’m hoping that is really my only problem.





So I’m confused about what replacement part to buy. There’s three prongs connected to the board, the only help the manual gives is saying it’s a 5VDC adjust, but no resistance level.



Does anyone know what it most likely would be?

IIRC, the 102 on the resistor means it's a 1K (10 and 2 zeros = 1000 ohm), but as most of my knowledge is based on bigclive.com youtube vidjeos, I'd double-check.

Lime2K said:

IIRC, the 102 on the resistor means it's a 1K (10 and 2 zeros = 1000 ohm), but as most of my knowledge is based on bigclive.com youtube vidjeos, I'd double-check.

Click to expand...

Wow thank you. That’s extremely helpful. Let me know if you find out anything else.