Hello,
Started working on an 4 slot board (MVH MV4 that I got in. On boot the board just sits at the hatch pattern. Pulled it apart and pulled the battery off to find a bit of leakage and 4 possible bad traces.
Are the schematics available any where? I searched and was unable to find them. I'd like to use cont on my meter to check if I have connection between components. If no scm is available what is the best way to test these, short of following vias and traces between components. I do not want to unnecessarily repair a trace just because it looks bad.
I am also working on a much worse off MV2F. Seems 28 legs of the NEO-ZMC2 chip are corroded, along with vias and traces. A schematic for this would be very helpful as well.
Thanks
-Syco54645
Started working on an 4 slot board (MVH MV4 that I got in. On boot the board just sits at the hatch pattern. Pulled it apart and pulled the battery off to find a bit of leakage and 4 possible bad traces.
Are the schematics available any where? I searched and was unable to find them. I'd like to use cont on my meter to check if I have connection between components. If no scm is available what is the best way to test these, short of following vias and traces between components. I do not want to unnecessarily repair a trace just because it looks bad.
I am also working on a much worse off MV2F. Seems 28 legs of the NEO-ZMC2 chip are corroded, along with vias and traces. A schematic for this would be very helpful as well.
Thanks
-Syco54645
