NEO-GEO AES 3-6 motherboard / Bypass RGB picture problem !

Hi I just tried the RGB bypass and the results are strange.
My image looks like really yellowish like colors are burned.
Sync is soldered on PIN 11 because on pin 10 I got almost no picture.
Can someone help me to see more clearly my mistake ?

(ps: I had no green cable so sync and green are both yellow cables)

Here some pictures:

All you had to do was cutting the traces. There's no point in bypassing the encoder as that's what outputs RGB at the correct voltage and impedance levels for a TV. Now you have MVS levels, good for arcade monitor, not for TV/broadcast monitor.

Ok, I will resolder the caps and resistances to bring it back to the original then. Thanks a lot for your advices !