Evan
Fio's Quartermaster
- Joined
- May 31, 2016
- Posts
- 487
Well, I got a new Neo Geo and when it arrived and I plugged it in it did not work. There is no clicking just a messed up screen. When I opened it up it was really dusty inside. It seemed that no one had opened it before, as the pads were hard to remove. I was looking around the board as it was a much later revision than my previous one. I assumed it would be ntsc because it came from japan but when I opened it there was one small wire going from a chip to a PAL part of the board. Also, on the part of the board that said ntsc only there was nothing. I don't know what the issue is but if anyone has anyone has ideas on what it could be that would be helpful.
EDIT: I checked the case and it is a NEO-0 so it is Japanese.
https://drive.google.com/file/d/1r54F00oM790Y31E4uH3spxarz79U0Tlg/view?usp=drivesdk
https://drive.google.com/file/d/1OEJxfcFBWKWmbVjKaNfnPAFNNmAIbCvA/view?usp=drivesdk
https://drive.google.com/file/d/1eDma0DWZgy_ztGam4LOcZmiHUSg4n2Yw/view?usp=drivesdk
EDIT: I checked the case and it is a NEO-0 so it is Japanese.
https://drive.google.com/file/d/1r54F00oM790Y31E4uH3spxarz79U0Tlg/view?usp=drivesdk
https://drive.google.com/file/d/1OEJxfcFBWKWmbVjKaNfnPAFNNmAIbCvA/view?usp=drivesdk
https://drive.google.com/file/d/1eDma0DWZgy_ztGam4LOcZmiHUSg4n2Yw/view?usp=drivesdk
Last edited: