Best case for a CMVS?

johhnnyD14

Hardened Shock Trooper
Joined
Feb 3, 2015
Posts
431
I'm looking to consolize an MVS board, ideally a small one like an MV-1C, MV-1FZ or MV-1A. I have no problem with the wiring, cords, etc, but my biggest issue in going forward with the project is trying to find a case that can fit one of these boards. Are there any cases out there that can fit one, or should I try something like 3D printing?
 

Heinz

Parteizeit
15 Year Member
Joined
Feb 13, 2005
Posts
22,333
The MV-1C wont be hard to find a case for, there are a lot that will suit it. Finding a case for a 1FZ or a 1A though might be tricky because they're both hori loaders and... I'm not sure there's a nice way to put those in cases without a bit of custom plexi work.
 
Top