- Joined
- Apr 21, 2001
- Posts
- 3,998
Hi, Thanks for the comments, I have 8 mini marquee and they all fit so this was my base for the design, I imagine they are all cut a little different and also 3d printing can also change from one print to another. Was it just the initial part that they would fit into I have found once they go past that it's ok and I just bend the middle while putting them in. So did I use yellow on one of the panels as well as the 12v ?
Lee
Some of the marquees fit fine (such as my KOF '98 one), so I think that its true that some are cut a little wider than others. Ones that didn't fit were Magical Drop 3 and Metal Slug 3. KOF '03 one is some custom one someone made that came with the cabinet when I bought it.
When placed in both slits, they'd bow out, but still fit in terms of closing the marquee lid. Since I prefer them flat, I'm fine with them being secured by one slit and a little piece of tape on top of the other side. No biggie.
Yup, yellow was used for the 12v and one of the panels. Not sure if that's standard, but just an FYI. I almost wired it wrong as a result, but double checked and corrected myself before I finished the wiring. Also, the 12v wires weren't stripped at the end like the others, so I had to strip them. Again, really minor stuff.
Pics attached.
Attachments
Last edited: