Ricard350
n00b
- Joined
- Oct 15, 2017
- Posts
- 35
I brought a SCART cable that said to eliminate checkerboard pattern, well it actually works!!
It turned out that its just 2x 130ohm 1/4 resistor in the scart connector wired between pin 7-11 and 15 (The Red, blue and green signal) to the sync (pin20).
The yellow wires...
I cutted them just to check (just basically just making it like any other scart cable) and now I have a slight checkerboard effect....
Now I guess I am just gonna solder them back together.....
Just curious as how just putting 260ohm resistance per color signal to the sync fixes it?
Anybody can explain that as I would like to know more about this....
Thanks
It turned out that its just 2x 130ohm 1/4 resistor in the scart connector wired between pin 7-11 and 15 (The Red, blue and green signal) to the sync (pin20).
The yellow wires...
I cutted them just to check (just basically just making it like any other scart cable) and now I have a slight checkerboard effect....
Now I guess I am just gonna solder them back together.....
Just curious as how just putting 260ohm resistance per color signal to the sync fixes it?
Anybody can explain that as I would like to know more about this....
Thanks