I finished wiring my CMVS this morning(MV1C), and after powering it on for the first time, there is obviously an issue. I'm really not sure where to start, but was hoping someone might be able to identify a good starting point? I should mention I was using component output here.
I'm using a Neobitz 2.4 Encoder. The only concern I had prior to powering on was the OE and CE traces(10 and 12) on the board. They were pretty corroded and fragile, and when I was clipping the legs on the stock bios chip to de-solder the legs and install the Unibios, the trace at pin 10 almost came off the board. Could a BIOS issue be responsible for this output?
Thank you all for any input!
I'm using a Neobitz 2.4 Encoder. The only concern I had prior to powering on was the OE and CE traces(10 and 12) on the board. They were pretty corroded and fragile, and when I was clipping the legs on the stock bios chip to de-solder the legs and install the Unibios, the trace at pin 10 almost came off the board. Could a BIOS issue be responsible for this output?
Thank you all for any input!