Kickin' Wing
Armored Scrum Object
- Joined
- Mar 14, 2004
- Posts
- 253
I'm borrowing a Japanese Cyvern PCB and am getting a garbage screen shortly after startup that says, "Clock Adjust" at the top and "Exit: Press 1P & 2P Start" at the bottom.
I have a 1L6B, so I wired in a second start button and it boots and plays fine after that--except TEST & SERVICE don't work.
I tried booting with DIP1 ON, but that goes to an even more garbage screen and it won't advance past there.
My only guess is the on-board CR2032 battery is dead, which brings me to the last issue.. the battery slides open into a giant heat sink :awe:
-wiNg+thanks
:edit:
Found I can set the date on that screen with the joystick and boot without having to use both start buttons. Also am able to access the Test Menu with DIP1, but not with the button--menu is also garbage and hard to navigate.
At one point I was able to credit feed with SERVICE and at another Up & Down on the joystick did not work.
I've reseated the cart and adjusted to voltage from just over 4.9 to just over 5V.
Right now I'm just chalking the button issue up to the E2's edge connector and the rest to the battery.
I have a 1L6B, so I wired in a second start button and it boots and plays fine after that--except TEST & SERVICE don't work.
I tried booting with DIP1 ON, but that goes to an even more garbage screen and it won't advance past there.
My only guess is the on-board CR2032 battery is dead, which brings me to the last issue.. the battery slides open into a giant heat sink :awe:
-wiNg+thanks
:edit:
Found I can set the date on that screen with the joystick and boot without having to use both start buttons. Also am able to access the Test Menu with DIP1, but not with the button--menu is also garbage and hard to navigate.
At one point I was able to credit feed with SERVICE and at another Up & Down on the joystick did not work.
I've reseated the cart and adjusted to voltage from just over 4.9 to just over 5V.
Right now I'm just chalking the button issue up to the E2's edge connector and the rest to the battery.
Last edited: