Salvio007
Mr. Big's Thug
- Joined
- Oct 29, 2012
- Posts
- 198
Hello gentlemen!
I originally had some minor issues with the video signal (solder needs to be refreshed), I'm now experiencing blurriness that occurs gradually within 5 minutes of turning on the cab. I realize its time for a Re-cap and a good place to start.
While doing this, I'd like to take advantage and refresh the solder on video as well.
Unfortunately, as you can see, the label with model number has been partially ripped off. All I know is that it's is (or WAS) a Wells Gardner..
Can any of you seasoned gentlemen tell which model this is?
I'm not even all that sure if the chassis is the original Wells, to be honest. Chances could be that someone had retrofitted the chassis onto what was once a wells frame and yoke.
Your feedback is greatly appreciated and looking forward to hearing from you.
Sal
I originally had some minor issues with the video signal (solder needs to be refreshed), I'm now experiencing blurriness that occurs gradually within 5 minutes of turning on the cab. I realize its time for a Re-cap and a good place to start.
While doing this, I'd like to take advantage and refresh the solder on video as well.
Unfortunately, as you can see, the label with model number has been partially ripped off. All I know is that it's is (or WAS) a Wells Gardner..
Can any of you seasoned gentlemen tell which model this is?
I'm not even all that sure if the chassis is the original Wells, to be honest. Chances could be that someone had retrofitted the chassis onto what was once a wells frame and yoke.
Your feedback is greatly appreciated and looking forward to hearing from you.
Sal
Last edited: