Hello guys,
First post on these forums
I'll be buying my first Neo Geo AES tomorrow, I'm excited!. In preparation of the big event, this week I've been setting up my Sony BVM-A20F1M with the following consoles:
-Moded RGB french Nintendo 64.
-SNES with RGB SCART cable Sync on Luma.
-RGB french NES with stock SCART cable.
-RGB french Master System II wiith stock SCART cable.
-Megadrive model 1 with RGB SCART cable.
To connect the SCART cables to the BVM I use a Female RGBS SCART to BNC adapter and plug everything in my X68 analog board.
This setup works very well on my NES, SNES and N64 but can't get the Master System II and the Megadrive to sync, both consoles work just fine with the same scart cables on two other CRT.
Any idea on what is going on? It appears to be SYNC issue, can't find any VRC or AFC setting in the menu, the monitor is settup to accept external sync and I've been playing with any sync setting I can think off without results.
Would you recommend mending the cable to sync on composite? I can solder but need more information to do this. Also, does a sync strike introduce a latency?
Thank you!
First post on these forums
I'll be buying my first Neo Geo AES tomorrow, I'm excited!. In preparation of the big event, this week I've been setting up my Sony BVM-A20F1M with the following consoles:
-Moded RGB french Nintendo 64.
-SNES with RGB SCART cable Sync on Luma.
-RGB french NES with stock SCART cable.
-RGB french Master System II wiith stock SCART cable.
-Megadrive model 1 with RGB SCART cable.
To connect the SCART cables to the BVM I use a Female RGBS SCART to BNC adapter and plug everything in my X68 analog board.
This setup works very well on my NES, SNES and N64 but can't get the Master System II and the Megadrive to sync, both consoles work just fine with the same scart cables on two other CRT.
Any idea on what is going on? It appears to be SYNC issue, can't find any VRC or AFC setting in the menu, the monitor is settup to accept external sync and I've been playing with any sync setting I can think off without results.
Would you recommend mending the cable to sync on composite? I can solder but need more information to do this. Also, does a sync strike introduce a latency?
Thank you!