- Joined
- Dec 18, 2010
- Posts
- 2,881
Greetings,
EDIT: Issues below were both fixed by installing in a proper AWSD cab.
Resolution was an auto-fix.
Communication cartridge for some reason keeps attempting to connect when on a supergun. When in a cab it goes right to the game after the first failed communication attempt.
NEW ISSUE: I can't get the guns to re-load. First shot works, then game calls for a re-load, but it doesn't work. Both guns have the mechanisms - but something isn't registering. Again - guns both work as I can enter my name, select my game, and get one shot off in the game - but once I need to re-load, i'm done - can't re-load. Anyone know the trick?
Trying to get an Extreme Hunting 2 setup running.
I have all the necessary parts:
-Guns
-EH2 Gun Sub PCB
-Wiring from I/O to Gun Sub
-I/O Expansion
-Cart / Mother
-All Net Comm board with Key Chip
I believe everything is connected properly. I am having 2 issues:
1. My screen is divided - green line down the middle of the screen and the startup shows on both sides of the green line instead of just in the center. This is on an HD CRT - I do have AWSD cabs, but for testing, it's much easier to use a CRT.
2. I can't get past the CHPC link screen. It does a test and then says "timed out". It then says "coin error" and restarts the link process.
Questions:
Do I need to have the All Net installed if i'm not going online?
If yes, does it need to be connected via Ethernet cable?
If yes, are there workarounds? (I don't have an ethernet connection point in the area where my cabs are).
Any ideas on the green line? Anyone else experienced the split screen? Possibly won't work on CRT w/supergun?
Thanks...
EDIT: Issues below were both fixed by installing in a proper AWSD cab.
Resolution was an auto-fix.
Communication cartridge for some reason keeps attempting to connect when on a supergun. When in a cab it goes right to the game after the first failed communication attempt.
NEW ISSUE: I can't get the guns to re-load. First shot works, then game calls for a re-load, but it doesn't work. Both guns have the mechanisms - but something isn't registering. Again - guns both work as I can enter my name, select my game, and get one shot off in the game - but once I need to re-load, i'm done - can't re-load. Anyone know the trick?
Trying to get an Extreme Hunting 2 setup running.
I have all the necessary parts:
-Guns
-EH2 Gun Sub PCB
-Wiring from I/O to Gun Sub
-I/O Expansion
-Cart / Mother
-All Net Comm board with Key Chip
I believe everything is connected properly. I am having 2 issues:
1. My screen is divided - green line down the middle of the screen and the startup shows on both sides of the green line instead of just in the center. This is on an HD CRT - I do have AWSD cabs, but for testing, it's much easier to use a CRT.
2. I can't get past the CHPC link screen. It does a test and then says "timed out". It then says "coin error" and restarts the link process.
Questions:
Do I need to have the All Net installed if i'm not going online?
If yes, does it need to be connected via Ethernet cable?
If yes, are there workarounds? (I don't have an ethernet connection point in the area where my cabs are).
Any ideas on the green line? Anyone else experienced the split screen? Possibly won't work on CRT w/supergun?
Thanks...
Last edited: