Hi All,
I have a Konami Lethal Enforcers JAMMA PCB incoming, was wondering if you can help me out with 2 questions:
1) does it require -5V?
2) I would require two light guns - can anyone point me in the direction of guns which would be compatible with this PCB? Plug and play solutions allowing them to be directly plugged into the connectors on the board are preferred but anything that can be made to work with some simple rewiring at the connector end is also fine.
Sound wise, from what I read up it gives mono off the JAMMA edge and stereo via a connector on the PCB so this should be fine, subject to whether it requires the -5V for it to work.
If there is anything else I should know or any standard maintenance needed to be done on this board let me know.
I have a Konami Lethal Enforcers JAMMA PCB incoming, was wondering if you can help me out with 2 questions:
1) does it require -5V?
2) I would require two light guns - can anyone point me in the direction of guns which would be compatible with this PCB? Plug and play solutions allowing them to be directly plugged into the connectors on the board are preferred but anything that can be made to work with some simple rewiring at the connector end is also fine.
Sound wise, from what I read up it gives mono off the JAMMA edge and stereo via a connector on the PCB so this should be fine, subject to whether it requires the -5V for it to work.
If there is anything else I should know or any standard maintenance needed to be done on this board let me know.
Last edited: