mikejmoffitt
Mickey's Coach
- Joined
- Feb 6, 2014
- Posts
- 578
Work has kept me almost entirely away from personal projects, so last weekend I sat down and made this:
https://github.com/Mikejmoffitt/FightStickMini/blob/master/
You can look at Top.stl and Bottom.stl. This is based on my old Floppy Drive Fight Stick:
http://mikejmoffitt.com/img/stick_final.JPG
I am looking how to build a single run for testing. The bottom part has a cutout to fit the common PS360 / etc PCB I see going around.
The stick is 190mm long, and has the Blast City layout reproduced 100%. Fits standard OBSF buttons and the JLF Sanwa stick mount. It would not be hard to add the fourth column of buttons.
Just looking for some feedback and suggestions for what could be done to it if anything. Not sure if I'll ever get it really manufactured because it's expensive to do so. If you want to get one printed however you want, be my guest.
https://github.com/Mikejmoffitt/FightStickMini/blob/master/
You can look at Top.stl and Bottom.stl. This is based on my old Floppy Drive Fight Stick:
http://mikejmoffitt.com/img/stick_final.JPG
I am looking how to build a single run for testing. The bottom part has a cutout to fit the common PS360 / etc PCB I see going around.
The stick is 190mm long, and has the Blast City layout reproduced 100%. Fits standard OBSF buttons and the JLF Sanwa stick mount. It would not be hard to add the fourth column of buttons.
Just looking for some feedback and suggestions for what could be done to it if anything. Not sure if I'll ever get it really manufactured because it's expensive to do so. If you want to get one printed however you want, be my guest.