- Joined
- Jun 29, 2005
- Posts
- 922
I've been working on reviving a friend's Punisher board and it plays great now, minus the fact that I get no sound. After doing some reading, I gather that this may be because it does not have an interface board to connect the q-sound board and the motherboard.
I found this page...
http://wiki.arcadeotaku.com/w/CPS1#CP_System_Dash
That details the pinouts for each of the connectors.
From what I can gather, I need to run the Jamma speaker + and - lines from the Q-Sound board CN9 to the mother board edge connector. Do I need to run 12v and ground lines between the two as well ? Any confirmation, help, or clarification would be greatly appreciated. Thanks.
I found this page...
http://wiki.arcadeotaku.com/w/CPS1#CP_System_Dash
That details the pinouts for each of the connectors.
From what I can gather, I need to run the Jamma speaker + and - lines from the Q-Sound board CN9 to the mother board edge connector. Do I need to run 12v and ground lines between the two as well ? Any confirmation, help, or clarification would be greatly appreciated. Thanks.
Last edited: