Kpj
Larfleeze, Wielder of the Orange Light. , formerly
- Joined
- Sep 7, 2001
- Posts
- 1,812
I could definitely make two 3-panel boards for the 6-slots but it would probably be very expensive since there are so few 6-slot owners on the pre-order list (and in general). I ended up going in multiples of 2 so that the 2-slot, 4-slot, and 6-slot versions of this would all use the same parts.
As for wiring up three 2-panel MV-EL boards it wouldn't be hard to make a custom wiring harness that just passes the last two signals to the 3rd panel. In fact, if you got a hold of two "MV-ELD 1/2" pcbs and one "MV-ELD 2/2" pcb, you could do it by just adjusting the pinout of the two small "in-between" jumper cables. I can make a diagram of the pinouts tonight if you want.
I understand that demand for a dedicated 6-Slot cab wouldn't be worth it; I have no problem frankensteining together (3) 2 panel boards. Yes, after quick examination, I saw that a few pins were being unused, so I planned on wiring up the third panel to these contacts. Thanks for the offer on the diagram, but I should be good to go. I just signed up to your pre-order list as well!