Recent content by jacklick

Well, I finally got around to messing with this and figured I would post fix. Is 5 years too long? I can report there were 3 traces that needed to be fixed. 1) One was obvious on the top side pin 19 of zmc2 (aka C1) 2) extremely small break on bottom of board going to zmc2-p10 (aka GBD0) 3)...

My first post here and hoping to get some advice. Steps already taken. 1) removed battery 2) vinegar and toothbrush to neutralize and clean corrosion followed by rinse and dry. 3) continuity check on several traces. Definitely have at least one jumpers to do. 4) tested on bench 5) Researched...