NoAffinity
Kuroko's Training Dummy
- Joined
- Mar 20, 2017
- Posts
- 74
Hi all. First time posting. Active member on some other forums (KLOV, Arcade Otaku), but wanted to come to the Neo experts for a Neo question.
I just picked up a Neo 25 candy cab (pic below), and of course with any new acquisition, there's things that need immediate attention, and things for the "long term" fix-it list.
On the immediate list is the game select button not working. Prior to buying, I witnessed the "Select" button on the control panel working to cycle through the games. I believe it even worked when I first got the cab home and unloaded last night - I demonstrated it to my daughter. 5 minutes later and ever since, it is not working. I am getting +5V, from the signal wire for the button to ground. I get continuity from the button end of the wire to the JAMMA harness end of the wire, and the connection appears good at the JAMMA harness (which it should, since I'm getting +5V at the button). The wire is connected at pin 26 (component side). The game board cycles through the games, letting attract mode for each game run for what appears to be a pre-determined duration, probably a minute or so per game. And I assume that is normal.
What to check next?
I just picked up a Neo 25 candy cab (pic below), and of course with any new acquisition, there's things that need immediate attention, and things for the "long term" fix-it list.
On the immediate list is the game select button not working. Prior to buying, I witnessed the "Select" button on the control panel working to cycle through the games. I believe it even worked when I first got the cab home and unloaded last night - I demonstrated it to my daughter. 5 minutes later and ever since, it is not working. I am getting +5V, from the signal wire for the button to ground. I get continuity from the button end of the wire to the JAMMA harness end of the wire, and the connection appears good at the JAMMA harness (which it should, since I'm getting +5V at the button). The wire is connected at pin 26 (component side). The game board cycles through the games, letting attract mode for each game run for what appears to be a pre-determined duration, probably a minute or so per game. And I assume that is normal.
What to check next?