Just PM'd Xian Xi about this, but in case he's not around thought I'd post this here too.
I want to check that I'm doing this right in the absence of any specific instructions for the particular 1 slot revision that I have. It's a NEO-MVH MV1AX
I want to replace the rechargeable battery with a holder and a CR2032 (ie non rechargeable).
Here's a pic of the battery area on the solder side of the board:
http://i59.photobucket.com/albums/g319/Dalek99999/PA140334.jpg
Which parts should I remove so that the board WON'T try to recharge the battery, and so that a replacement CR2032 battery WILL retain the usual battery-backed data?
Many thanks
Addendum: Many thanks to Xian Xi - the components to remove are D1, D2 and R10
I want to check that I'm doing this right in the absence of any specific instructions for the particular 1 slot revision that I have. It's a NEO-MVH MV1AX
I want to replace the rechargeable battery with a holder and a CR2032 (ie non rechargeable).
Here's a pic of the battery area on the solder side of the board:
http://i59.photobucket.com/albums/g319/Dalek99999/PA140334.jpg
Which parts should I remove so that the board WON'T try to recharge the battery, and so that a replacement CR2032 battery WILL retain the usual battery-backed data?
Many thanks
Addendum: Many thanks to Xian Xi - the components to remove are D1, D2 and R10
Last edited: