plugging in a monitor?

well, I am switching powersupplies in my cab. I am taking out an Omron s8xa 500 or whatever and butting in a generic jamma powersupply from ebay.

The other powersupply had a 2 prong plug for the monitor to plug into and I want to make one that it can plug into from this one too.


here's the question...


the power supply I am putting in there says 115v on it. The plug that the monitor was going into had a label on it that said 100v 150w.

can I use this for a two prong plug?

and, how would I do this?


there's also a two prong plug in the back of the cab next to the on switch....can I use my powersupply for the rest of the stuff and just plug my monitor in there?

.............

Hey dont shoot the messenger , Im shure youre familiar with this page but ...if youre going to rebuild the p;ower supply you might as well rebuild the whole thing right , Im sorry ask specific qeustions if this doesnt help :
http://www.dameon.net/BBBB/buildit.html
look half way down at the diagram .