i fi put a two slot in without select button.

right now i have a one slot original mvs cab (MV-1f) and i was thinhking about getting a two slot board. If I didn't put a select button in, would the intros just play in a loop and i would hit start at the title srceen that i want to play?
and is there a simple guide to adding a select button somewhere. I'm pretty green when it comes to soldering and stuff.

thanx

It will cycle and you can coin it.

Adding a select button should be really easy........

Just find a way to attach (you don't nessacarily need to solder) a wire from the jamma harness to a button to the ground.

ok thanx.

get a "momentary push button"...$2.00 or so at radio shack. Sure it's more then online, but there's no shipping and it's only one part.

It should have a 2 pins on the back of it....

connect one side to pin 26 on the jamma harness and the other to ground (far 4 pins on either side of the harness) or straight to a ground on your powersupply.

oh, and it does NOT matter which side goes to what.....

mount the little F'r on your cab somewhere and bam, you have a game select button for a 2,4, or 6 slot.


If you get brave, you can also add a pause button to your cab very easily It's great for when the phone rings or the bathroom calls

i figured it wasn't all that hard. i'm just not very electro-savvy. I'm gonna start keep my eyes open for some multi slot boards and get back to you guys.

thanx

Momentary is great, but if you would like to use other Jamma PCB's, I'd recomend a toggle of some sort. a handfull of jamma pcb's require a toggle.

Also if your going from mono to stereo, plese note the other changes that have to be made.