chris1
POCKETBIKE NUT,
- Joined
- Oct 18, 2002
- Posts
- 10,830
I notice a lot of posts where people have problems with MVS boards not working properly due to the power supply being...All of the sudden to low on voltage..
How the heck does this occur...?
Does this just happen out of the blue?..Why?
What causes this,and how did the power supply suddenly get to low and need to be raised?
Does this mean that a future problem is going to happen..
Somethings breaking down..getting old like the board or the power supply?
What's next..?
Will it need to be raised again..Or does this happen when high in meg carts are used?
I've never had this problem..but I'd shit if I did,I mix all kind of carts in the cab and have no problem..
If this did happen to me then I would like to know why?
I can't understand why a perfectly working cab all the sudden needs the power supply voltage to be raised..
Explain please..?
I asked this in this thread too.
http://www.neo-geo.com/forums/newreply.php?s=&action=newreply&threadid=63673
How the heck does this occur...?
Does this just happen out of the blue?..Why?
What causes this,and how did the power supply suddenly get to low and need to be raised?
Does this mean that a future problem is going to happen..
Somethings breaking down..getting old like the board or the power supply?
What's next..?
Will it need to be raised again..Or does this happen when high in meg carts are used?
I've never had this problem..but I'd shit if I did,I mix all kind of carts in the cab and have no problem..
If this did happen to me then I would like to know why?
I can't understand why a perfectly working cab all the sudden needs the power supply voltage to be raised..
Explain please..?
I asked this in this thread too.
http://www.neo-geo.com/forums/newreply.php?s=&action=newreply&threadid=63673
