Wiring Help

I just got my neo 29 candy cab and my 1-slot and I have no clue how to wire this thing, I went to hardMVS but it doesn't show where the wires go. Can someone help me?

Is there any sort of harness included with your cab or are the wires just all over the place?

There is a Jamma Harness.

Are any of the wires actually attached to the harness? If not, you'll have to use the Jamma pinout guide on <a href="http://www.hardmvs.com" target="_blank">www.hardmvs.com</a> and connect up the wires to the harness. Then, be sure your power supply, monitor and controls are connected.

A detailed pic would help as it's kind of hard to figure out exactly where you need to start.

Hey,

I also have a Super Neo 29 and the Jamma Harness was alreday there, just had to plug in the board, I thinking that there is only one way to plug in the harness. I got mine from <a href="http://www.arcade-infinity.com," target="_blank">www.arcade-infinity.com,</a> so all they told me was no wiring necessary, just plug in the board and turn on the power. I hope this helps.

Hello,

I too have a Super Neo 29 with a 4 slot. But I want to put a PolyGame Master in it and don't know how. I took some pics of the inside and can email them to anyone who can lend me a hand.