Vendest
Krauser's Shoe Shiner
- Joined
- Jun 23, 2016
- Posts
- 240
Hi,
A friend gave me a non working PVM-1442QM.
He told me that the fuse is blown and that he replaced it as well as 2 transistors on the FE board.
While the 2 transistors match with the component listed on the manual, the fuse installed was rated 10A! instead of 4A time-lag.
Anyway I have replaced the fuse and check that the 230Vac goes thru. Regardless the monitor doesn't turn on. Probably other components went bad since the 10A fuse did not blow.
Not sure where to start looking right now. any suggestions?
A friend gave me a non working PVM-1442QM.
He told me that the fuse is blown and that he replaced it as well as 2 transistors on the FE board.
While the 2 transistors match with the component listed on the manual, the fuse installed was rated 10A! instead of 4A time-lag.
Anyway I have replaced the fuse and check that the 230Vac goes thru. Regardless the monitor doesn't turn on. Probably other components went bad since the 10A fuse did not blow.
Not sure where to start looking right now. any suggestions?