RGB molex / monitor connection

I'm fairly certain the small harness pictured below has a short or is failing to connect properly as wiggling the wires causes red to flicker on and off.

Anyone know where I can get a replacement or at least the connector part numbers so I can wire my own?

Still working on my machine. I posted pictures of the controls rebuild a while back but never got around to doing the body work and replacement vinyl yet. Eventually I'll wrap this thing up. haha

I believe I used one of this to wire up to my monitor
http://www.mouser.com/ProductDetail...3IeF61eD70wfjSOUgDMlk0L3oHiNpm1IvCpBesqTqXQ==
It's a 10-pin housing made by AMP.

And I think these are the crimp pins that go with it
http://www.mouser.com/ProductDetail...GAEpiMZZMs%2bGHln7q6pm0tcbBCZEwb8ncrO9kH6LII=

Could have been these too:
http://www.mouser.com/ProductDetail...EpiMZZMs%2bGHln7q6pm5E1Eb6qwPl2U2kc9TOJ%2brQ=

I recall there being far too many options for pins, lol.

haha, cool. I'll take a look. Thanks for the info!