PDA

View Full Version : Naomi to RGB Scart



Beaps
11-22-2014, 06:26 AM
Hi All,

I am trying to connect my Naomi system to my BVM via RGB Scart. I have flicked the jumper to set it to 15khz but I getting like a vibrating interlaced image.

Here is how I got it setup

http://s1.postimg.org/kcmttq76z/Naomi.jpg (http://postimg.org/image/kcmttq76z/)

When I go into test mode I get this

http://s27.postimg.org/6rnjpt827/IMAG0356.jpg (http://postimg.org/image/6rnjpt827/)

Is there another dip switch I need to switch. Currently I have 1UP the other 3DOWN.

Any help would be appreciated

Beharius
11-22-2014, 07:46 AM
You need resistors... Like 220ohm

Beaps
11-22-2014, 08:02 AM
On what the RGB lines or the Sync line?

Beharius
11-22-2014, 08:50 AM
All signals, R,G,B and S.

Beharius
11-22-2014, 09:22 AM
I also noticed that you are connecting both sync signals(H&V) to the pin20, it's incorrect. You can use the composite sync line on the jamma connector instead or Kenzei (beharbros.com) to combine those separate sync signals into one Csync compatible with the Scart.

Naomi (VGA) - Kenzei - Scart (still need the resistors though)

Naomi (through Sega I/O jamma) - Scart with resistors

skate323k137
11-22-2014, 10:50 AM
I use a capcom IO, run the video from the dsub to that, then jamma to scart with 220 ohm resistors. Works perfect, and there's a switch inside the capcom I/O that handles the sync.

Beaps
11-22-2014, 11:19 AM
I think I got it sussed. I am using a regular ATX power supply and I don't think it's powerful enough

Beharius
11-22-2014, 11:28 AM
Atx is fine, I use it too...

Beaps
11-22-2014, 11:33 AM
It's only 200w, is that powerful enough

Beharius
11-22-2014, 11:40 AM
Yes. Your issue is a sync problem, you either need to wire it from the jamma connector with resistors or use a sync combiner (like Kenzei) + resistors in the scart cable

Atro
11-22-2014, 01:22 PM
the resistor value used on the sync line may be higher than 220 ohms if you're sending +12V instead of +5V.

kuze
11-22-2014, 01:31 PM
It's only 200w, is that powerful enough

I run a 175w atx PSU and haven't had any issues powering supergun, capcom io, Naomi, netdimm and raspberry pi off of it. Older PSUs from the era seem to work best.