Vampire kick harness problem FIXED

Green Beret

Fio's Quartermaster
Joined
Feb 27, 2013
Posts
498
I have connected kick harness as normal with correct pinout. 2 player all kicks work fine but 1st player there is no light kick. Measured the cable but it's fine.
On my fingerboard the 4th button is connected to use with neo geo.
Is there a conflict?
 
Last edited:

Green Beret

Fio's Quartermaster
Joined
Feb 27, 2013
Posts
498
Is there any chance this to be a b board's fault.
Sorry guys for the newbie question but it is the first CPS2 board I get and don't have the experience.
 
Last edited:

aha2940

AH, A, COLUMBIAN!,
Joined
Dec 15, 2013
Posts
2,528
Is there any chance this to be a b board's fault.
Sorry guys for the newbie question but it is the first CPS2 board I get and don't have the experience.

If you know which pin on the board is the one for P1 Low Kick, you can check it for a broken trace or some other obvious problem.

I have no CPS2 experience, just some generic advice, sorry.

Regards.
 
Last edited:

Green Beret

Fio's Quartermaster
Joined
Feb 27, 2013
Posts
498
In that game and only for player 1, you have to disconnect the 4th jamma harness button. There must be only 3 jamma buttons connected and the kich harness for rest 3.
Fourth button was causing a conflict and short cicuit with the 1st kick button.
 
Top